Description
Product Specifics
Placement on Vehicle: Front+Left+Right+Upper
Type: Control Arm & Ball Joint Assembly
Universal Fitment: No
Control Arm Construction: Forged
Items Included: Mounting Hardware
Custom Bundle: Yes
Interchange Part Number: K9815,K9816
OE/OEM Part Number: Suspension Control Arms and Ball Joints Assembly
Superseded Part Number: Front Driver And Passenger Side Replacement
Manufacturer Warranty: 10 Year
Brand: ECCPP
UPC: Does not apply
Manufacturer Part Number: E80109001CP
Adjustable: Yes
Modified Item: Yes
Kit Parts Included: Control Arm, Ball Joint
Kit or Single Part: Kit
Greasable or Sealed: Greasable
OE Spec or Performance/Custom: OE Spec
Surface Finish: Polished, Rust Protected
Suspension Grade: Standard
Quantity: 2 Pcs
Cross Part Number: 51450SM1A03, 51450SM4023, 51460SM1A03, 51460SM4023 K9815
Fitment: For 1990 1991 1992 1993 Accord Honda Kit Set
Bundle Description: 1x Right 1x Left Upper Front Control Arm and Ball Joint Assembly
Features: Greasable
Cotter Pin Hole: Yes
Material: Alloy Steel
Mounting Style: Bolt-On
Finish: Coated
Suspension Control Arm Replacement Guideline
Control arms are installed in pairs on the front and rear axle and connect the chassis to the wheels as part of the suspension. Therefore, they have a significant influence on the driving characteristics of the vehicle.
A dynamic or a comfortable driving style? The control arms are individually adjusted to the vehicle depending on the desired characteristics. They also absorb lateral movements and forces resulting from driving off and braking.
Picture(A)
Warning
Warning:Depending on the axle design, the control arm may need to be secured against falling with a suitable device, e.g. a transmission lifter.
2.Treat the fixing screws and nuts of the control arm with rust solvent and leave it to work for a few minutes so that they are easier to loosen.
3.On vehicles with automatic headlight levelling, it may be necessary to detach the leveling sensor from the control arm.
Picture(C)
4.If the stabilizer is connected to the control arm, the next step is to loosen and remove the corresponding stabiliser fixing screws.
5.Loosen and remove the control arm fixing screws.
6.Loosen the ball joint at the steering knuckle with a suitable special tool (e.g. a puller).
7.Remove the old control arm.
Picture(D)
8.Clean the mounting flange of the ball joint pin on the steering knuckle with sandpaper and then with brake cleaner. Otherwise single rust particles can enter the new control arm joint via the ball pin, potentially leading to premature failure of the joint.
Picture(E)
9.Fit the new control arm with the supplied accessories and attach new fixing screws and nuts.
Picture(F)
10.Reattach the stabilizer and, if applicable, the leveling sensor for headlight leveling to the control arm.
A defective control arm can manifest in the following ways
(1).Noise (squeaking, creaking, rumbling).
(2).Deteriorating driveability.
(3).Increasingly woolly and imprecise steering.
(4).Uneven tyre wear.
Tip:If the control arm is in working order, it is possible to only replace the defective bearings and joints. However, replacing bearings, control arm bushings and ball joints can be very complex and costly.
Picture(B)
1.First lift the vehicle using a car lift, ideally a wheel-free four-post car lift. This makes it easier to correctly tighten the control arm fixing screws.
Reviews
There are no reviews yet.